Ensys
about
efficiency redefined

Hydro Pneumatic Systems:

dp2

These systems can be classified into 3 types:

  1. Tank Feeding Systems - These are typically used to fill up different overhead tanks from one central tank.
  2. Tap Feeding Systems - These are used where all the taps are supplied with pressurized water from the central tank.
  3. Curing Systems - These are used during construction period for curing purpose. With this huge amount of water is saved.
dp1

The hydro pneumatic system consists of a pressure pump and a pressure tank. The pressure tank consists of a rubber bladder surrounded by pressurized air. Water being a non-compressible fluid, pressurized air is used. When you open, say a tap or shower knob water from this pressure tank is utilized. As the water is utilized the pressure in the tank is reduced. This pressure drop is sensed by the pressure switch and the pump is turned ON. Once the set pressure is achieved, the pump shuts OFF. This is done so as to reduce more ON/OFF’s of the pumps. This increases the life of the pumps.

This system works automatically and no manpower is required.

We design the system based on the Clients’ requirement, site conditions and most importantly based on Piping Design, as Pumping & Piping goes hand in hand. Our expertise is to understand the Piping Design and then design the Pumping System.

As we Design the systems we can use all types of pumps, as required by the client. As each system is designed, we take care in selecting pumps, which gives the highest efficiency.

To continue our Core Belief of “Efficiency Re – Defined”, we have taken a dealership of “dp pumps” Holland for high efficiency Vertical Inline Pumps and all types of submersible Sewage Pumps. “dp pumps" is a leading Brand in Europe and is a part of the World’s largest manufacturers of Pumps, KSB AG.

“dp pumps” has a large installation base in India and has a full fledge Sales & Service office in India.